The actual layout and/or filling of the Instrument Case may differ from the schematic below. It depends on the size of the connector series, the number of gauges that are advisable for that connector series, and whether it is a Standard, or a Professional Kit. The layout of the Instrument Case itself for the Standard and the Professional Kits are identical. This is very advantegeous, as someone can start with the Standard Kit, and fill the empty spots at a later stage to expand to the Professional Kit. Each instrument Case contains a space where the appropriate Torque Wrench can be fitted.
The actual layout and/or filling of the Instrument Case may differ from the schematic above. It depends on the size of the connector series, the number of gauges that are advisable for that connector series, and whether it is a Standard, or a Professional Kit. The layout of the Instrument Case itself for the Standard and the Professional Kits are identical. This is very advantegeous, as someone can start with the Standard Kit, and fill the empty spots at a later stage to expand to the Professional Kit. Each Professional Kit contains already the appropriate Torque Wrench.
INFORMATION ON HOW TO ORDER CONNECTOR GAUGES: Spectrum Elektrotechnik GmbH has set up an easy to use part number system. The customer can compose his part number, describing completely the Connector Interface Gauge Kit, he is ordering. The table below explains the system and describes the possible alternatives.
THE MEASUREMENT: The Letter B identifies the units of the dial readings, which either can be in millimeters or inches.
THE CONNECTOR SERIES: The four letters CDEF are used to recognize the connector series, the Kit is needed for. Please replace these four letters by the code used for identifying the connector series, as listed below.
THE KIT: The letter H is to be replaced by the letter S when a Standard Kit is ordered, and by the letter P, when the Professional Kit is specified.
THE TYPE OF GAUGES: The Gauges are usually available as “Hand-held” or “Thread-on”. The faster testing is possible by using the “Hand-held” gauges, the more accurate readings will be achieved from the “Thread-on” gauges, as threading on the gauges will perfectly align them with the connector. Hand-held means aligning gauge and connector freely, which may allow for mistakes. The letters JK are to be replaced by HH, when Hand-held gauges are specified, and with MG, when Thread-on gauges are needed.
THE RESOLUTION: The letter L has to be replaced by the code that is used to identify the resolution. Resolutions of 0.01mm to 0.001mm, and 0.001 inches to 0.0001 inches are available. For the appropriate letter coding please refer to the table below.